Any equipment or installation is exposed to some specific defects that occur during its use. Many of them can be easily repaired, but some require our specialized knowledge and skills. To avoid such problems, which can be particularly troublesome when it comes to plumbing, it is appropriate to deal with installations. To this end, regular checks and inspections, so that potential failures are detected before they even occur. Such inspections simply call the appropriate service to on-site check everything thoroughly. All it will take a little time, and with such a service gain confidence that will not meet us serious problem.
Materials used in plumbing
Water systems in ancient times used gravity to move water. They used pipes or channels usually made of clay, lead, bamboo or stone. Today, water-supply systems use a network of high-pressure pumps, and pipes are now made of copper, brass, plastic, or other nontoxic material. Drain and vent lines are made of plastic, steel, cast-iron, and lead. Lead is not used in pipes today because it can be poisonous.
The 'straight' sections of plumbing systems are of pipe or tube. A pipe is usually made by casting or welding, where a tube is made through extrusion. Pipe usually has thicker walls and may be threaded or welded, where tubes have thinner walls, and needs special joining techniques such as 'brazing', 'compression fitting', 'crimping', or for plastics, 'solvent welding'.
As well as the straight pipe or tubing, many fittings are required in plumbing systems, such as valves, elbows, tees, and unions.
Plumbing fixtures are designed for the people who use the water. Some examples of fixtures include water closets (also known as toilets), urinals, bidets, showers, bathtubs, utility and kitchen sinks, drinking fountains, ice makers, humidifiers, air washers, fountains, and eye wash stations.
Facts from Wikipedia
Water systems of ancient times relied on gravity for the supply of water, using pipes or channels usually made of clay, lead, bamboo, wood, or stone. Hollowed wooden logs wrapped in steel banding were used for plumbing pipes, particularly water mains. Logs were used for water distribution in England close to 500 years ago. US cities began using hollowed logs in the late 1700s through the 1800s.8 Today, most plumbing supply pipe is made out of steel, copper, and plastic; most waste (also known as "soil")11 out of steel, copper, plastic, and cast iron.11
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.